Avalon litecoin pools
Upon upgrading your firmware, you need to let the upgrade take place for like minutes until it is clear the process is complete. Power on the Avalon 6 when you start to click the upgrade.
That should be enough to repair your firmware you upgraded. And, if you still have problems, please contact support. This answer assumes you have your AvalonMiner setup and connected to your AvalonMiner Controller or other controller Raspberry Pi 1, 2, or 3 running the latest software Canaan released for your supported hardware.
Once you have your controller working and can access it from a simple web browser. By default our miners are set to CKPool https: Also, by default there is a mining pool user set that needs to be changed. There are two ways to change this setting. One is to change the default user to your Bitcoin wallet address. The second way is to create a CKPool account as described on the main page of their website: Once you have created your account on CKPool, go back to the Cgminer Configuration panel loaded from your controller in a simple web browser.
Canaan is the sole service center for AvalonMiners. If you need a replacement part and it is not available in our shop , please create an account and submit a ticket. Skip to content Please follow the instructions of this simple setup guide: Please make sure to first turn off and keep your power supply unplugged. Then, the power supply on and off switch controls the power on or off for your power supply.
The Avalon 6 use the same driver with Avalon 4. And the default value is Here however are guides which can help with this process if you want to proceed at your own caution: This FAQ is an attempt to repair that issue. First, you need to visit this page: This rate, expressed in litecoins, also takes into account merged-mined coins such as Dogecoin, resulting in higher payouts than a regular Litecoin pool.
Thanks to merged mining, you have to pay no fee; in fact, your earnings may even be higher than with a 0-fee PPS system. On other systems, miners are only rewarded when and if a block matures, but sometimes blocks get orphaned from the Litecoin network, and therefore yield no reward.
A PPS pool, on the other hand, takes on the risk of bad luck so you don't have to deal with variance and orphaned blocks. Since the very start, the pool used ad-hoc software: Pooler wrote the front end entirely from scratch, with security and efficiency in mind, while the mining back end was originally a heavily-modified version of Jeff Garzik's pushpool.
After two weeks of intensive testing, on November 5, the pool opened its doors to the public, becoming the first PPS pool for Litecoin.
In April LitecoinPool. Due to centralization concerns, it was decided to temporarily close new registrations; later in , registrations were reopened, but have since been subject to approval. In August the back-end software was completely redesigned and rewritten from scratch to implement advanced efficiency and scalability optimizations that Pooler devised after implementing support for the Stratum protocol in cpuminer.
This new implementation makes LitecoinPool.